Pfsense webui IP is your lan gateway IP that you set TheBigGame117 2 yr. Routing table for Computer B: Destination Gateway Genmask Flags MSS Window irtt Iface After you assigned the gateway, you probably will need go to pfsense webui to finish up the setup.

pfSense can not ping Computer B at 192.168.77.1.

Computer B can not ping pfSense at 10.0.0.1.Computer B can not ping anything on the Internet How we do NAT port forward in pfSense Our Support Engineers do the NAT port forwarding via the web GUI.Computer B can ping Computer A at 10.0.0.2.Computer A can ping Computer B at 192.168.77.1.I then add a route: route add 192.168.77.0/24 10.0.0.2 wan : vtnet0 5.6.7.8/32 (my ip failover) lan : vtnet1 192.168.1.1 (my lan for the VMs) The thing is pfsense can connect to the internet, can ping as well as 8.8.8.8 but the VM I've set up can conect to the internet nor ping or 8.8.8. Sometimes Ive had this issue with Pfsense in a virtual machine. In reality, the IP address on the WAN port is a private IP address which is not. Usable IP range is XX.XX.XXX.201 through XX.XX.XXX.205, Gateway is XX.XX.XXX.206. On the pfSense router I add a firewall rule to allow traffic with source: 192.168.77.0/24, destination: any. In this module, we will look at setting up a pfSense firewall VM in. I enable IP forwarding and add a route: sysctl -w _forward=1 This interface does not have an IP address assigned.

Then I added a default route: ip route add default dev eth0Ĭomputer B is plugged into eth1 of Computer A. I'd like to configure Computer A to act as a router.Ĭomputer B has a ethernet interface (eth0) configured with an IP address 192.168.77.1/32. Computer A has two interfaces, one connected to Computer B and the other connected to a pfSense router. I am experimenting with networking and trying to get the following to work.

Pfsense vtnet0 no ip